FP6Индивидуална стипендия2006–2008

QUSOB · Ultrasonic assessment of osteoporosis in cancellous bone

6РП — Действия „Мария Кюри“

Период
2006-11-01 → 2008-10-31
Финансиране от ЕС
158 786 €
Участници
1
Схема
EIF

Линиите свързват координатора с партньорите.

Накратко на български

Ултразвуковите вълни в гъбчатата кост се анализират чрез измервания върху човешки бедрени стави и 3D модели. Това помага за проверка на теоретичните модели за разпространение на вълните, което е важно за по-добрата оценка на остеопорозата.

Този кратък обзор е генериран от изкуствен интелект

Кратко обяснение, генерирано от езиков модел по текста на CORDIS. Оригиналът е по-долу.

Резултати накратко

Final Activity Report Summary - QUSOB (Ultrasonic assessment of osteoporosis in cancellous bone)

The project was focused on coupled experimental, numerical and theoretical studies of ultrasonic wave propagation in cancellous bones, aiming at the validation of theoretical models of elastic wave propagation in such materials. It was proposed to achieve the goal by: (i) analysis of the data obtained from ultrasonic studies, numerical simulations of wave propagation in real 3D trabecular bone structures, reconstructed from micro-computed tomography; and (ii) analysis of existing/developed models of propagation of elastic waves in heterogeneous materials. Within the project, 26 slabs of cancellous bones were prepared from fresh human femoral condyles. The main part of the project was concentrated on the ultrasonic (US) measurements performed on intact specimens (i.e. with marrow inside) and subsequently on water- and alcohol-saturated samples (i.e. the marrow was removed). One of the key point of the studies was the comparison of the site matched ultrasonic data (signals, wave parameters, etc.) obtained from the same specimen at different frequencies (0.5, 1, and 2 MHz) and saturated with different fluids. It was found that, the changes of absorption conditions (by replacement marrow by water in the pores) in the fluid or at the fluid / trabeculae interphases (decrease of the friction) did not lead to expected decrease of the values of attenuation coefficient. Moreover, significant alteration of scattering conditions (acoustic impedances at the fluid / trabeculae by replacement of the marrow/water by alcohol) also was not reflected in the attenuation. Second important part of the project was focused on the evaluation of structural parameters of the cancellous bones based on the data acquired from micro-computed tomography. The reconstructed 3D models of bone micro-architecture, obtained from the same bone regions of interest (ROI's) as the US studies, were used twofold: (i) to calculate structural parameters and (ii) as an input data for numerical simulation of elastic wave propagation. The set of structural parameters obtained from the ROI's, site matched with US studies, shows less than 10 % bone volume fraction (BV/TV) of this area. Moreover, the range of values of the structure model index (1.5 - 2) and degree of anisotropy (1.3 - 2.3) indicate that the structure is not highly oriented. The results of numerical simulations (signals transmitted through 3D bone micro structures) were compared with results of ultrasonic experiments. The main conclusion of these studies is that the attenuation coefficient increases both in the experiments and simulations as BV/TV increase. The simulated and measured phase velocities are very close, particularly for higher (1 & 2 MHz) frequencies. Until the end of the project, there was not possible to validate or invalidate theoretical model. The mostly used macroscopic Biot's model (which doesn't include scattering effects) is very sensitive to the fluid viscosity. Change of the fluid viscosity (three orders of magnitude) is reflected in theoretical attenuation, while in the experiments practically no difference is observed. In contrary, the attenuation predicted by the scattering model (Faran model) is sensitive to the elastic properties of the fluid filling pores. Accordingly to such models, attenuation of alcohol saturated bones should be higher than of water-filled specimens, while in the experiments rather opposite behaviour is observed. In summary, despite the lack of clear identification of the attenuation mechanisms in cancellous bones characterised by less than 10 % values of BV/TV, the studies concerning this issue will be continued. The ultrasonic data were not fully exploited yet due to unforeseen problem of the separation of mixed waveforms of the transmitted radio-frequency signals measured in the more dense ROI's. The waveform overlapping preclude any reliable analysis within these ROI's, therefore the problem of wave separation is currently under investigation.

Текст от CORDIS, на английски · Данни: CORDIS, © Европейски съюз

Цел на проекта

Osteoporosis is metabolic bone disease leading to be enhanced bone fragility and as a consequence increases in fracture risk. The socio-economic burden of the disease has triggered considerable effort to develop new and cost-effective methods for early detect ion, prevention as well as treatment. Radiation free quantitative ultrasound (QUS) offers the advantage of relatively low cost and portability compared to X-ray densitometry, and is currently considered as the most promising tool for assessment of bone quality. Ultrasonic waves have the potential to assess both mechanical and structural properties of bone as well as their deterioration due to osteoporosis. However, till now, mainly because of the lack of proper theoretical model, it is difficult to use available advanced signal processing techniques to extract of mechano-structural characteristics of cancellous bone.The scientific aim of the project is to develop and validate theoretical model of propagation of ultrasonic waves in cancellous bone useful in solving direct or inverse problem toward quality assessment of bone. This goal will be achieved by analysis of the data obtained from: synchrotron microtomography (SR-µCT); combined transmission/reflection ultrasonic studies coupled with innovative compute r simulations of wave propagation in real 3D trabecular bone structures reconstructed from SR-µCT and analysis of existing/developed models of propagation of elastic waves in inhomogeneous materials. If successful, in a short-term perspective, it will be possible commercially disseminate the developed model-based methodology into clinical measurements in new versions of QUS devices. Realization of the scientific project will contribute to the fellow professional maturity toward the preparation of habilitation thesis, important scientific degree in Poland, which is essential precondition to organize a research team and draw broader attention of younger researchers to the subject of the proposal.

Оригинален текст от CORDIS (на английски).

Участници

  • UNIVERSITE PIERRE ET MARIE CURIE - PARIS 6 · PARISКоординаторФранция

Връзки

Данни: CORDIS, © Европейски съюз